Subscribe to Blog via Email Enter your email address to subscribe to this blog and receive notifications of new posts by email.

You can also use old M.2 or PCIe SSDs by buying an USB3.0 adapter.

Make sure to use USB 3 and performance will be fine.

Get USB Network adapters A single network adapter per host is not sufficient for most homelabs.

Buy additional USB3 network adapters to expand the possibilities.

Installation instructions and recommended adapters are explained in more detail here: Additional USB NIC for Intel NUCs running ESXi.

Activate AMT Remote Management (vPRO only) If you have the NUC5i5MYHE with vPRO technology, you can activate remote management including KVM with VNC.

The remote management uses the NUCs network port and can be shared with ESXi.

Enter the BIOS to verify that WOL is enabled: Power Secondary Power Settings Wake on LAN: Power On To use WOL you need the physical network adapters MAC address.

You can identify the MAC address in the ESXi Configuration within Manage Networking Physical Adapters When you want to power on the NUC you have to send a Magic Packet to the MAC address.

Software is available for Windows or most Linux distributions, for examaple a debian based Raspberry Pi: rootpi: apt-get install wakeonlan.

Sending magic packet to 255.255.255.255:9 with b8:ae:ed:75:08:68 Get a Raspberry Pi Integrate a Raspberry Pi to you homelab to have a static always on system.

You can use it as DNS server, jumphost, for monitoring, as backup host or anything else that you want to have outside your platform.

Edit Power Policy Settings Intel NUC supports ACPI P-states and C-states.

P States set the CPU to a lower frequency and C states are power saving modes.

The default mode is Balanced, which is good for most systems.

This will allow the ESXi to lower the core frequency and set idle Cores to stop (C2).

Cores in C2 will require about 10 less energy, but going back to operating mode requires about 50s.

If you need full performance, set the policy to High performance, which will disable any PC states.

ESXTOP in the power screen ( p ) reveals information about P and C states: Measure Power Consumption Depending on your location, your power bill when running a homelab can increase drastically so keep an eye on your power consumption.

You can either buy a cheap pluggable power meter to measure your homelab or integrate it into your home automation.

Im using a HomeMatic based power measurement system with a Graphite backend.

VMUG Advantage EVALExperience, part of VMUG Advantage enables you to use evaluation licenses for all main VMware products required to run a VMware bases homelab.

Subscription is avilable for 200 per year and includes other goodies.

Share: Twitter Facebook Reddit WhatsApp LinkedIn Related posts: Howto: Intel NUC Remote KVM with AMT (powered by vPro) VMware VSAN on Intel NUC - Mobile Cluster for 2000 vSphere 5 Homelab ESXi on Intel NUC Additional USB NIC for Intel NUCs running ESXi VMware Homelab in 2015 - Systems Revised with vSphere 6 Tags: Homelab NUC Leave a Reply Cancel reply Your email address will not be published.

Comment Name Email Website Notify me of follow-up comments by email.

Intel Amt Vnc For Mac